Victron Orion-TR Smart DC-DC 24/24-17 17a (400W) Isolated Charger or Power Supply

Victron Orion-TR Smart DC-DC 24/24-17 17a (400W) Isolated Charger or Power SupplyOrion TR Smart Isolated DC DC Converter 24 VDC to 24 VDC 400W 17AMP The Orion Tr Smart DC DC charger is a professional DC to DC adaptive 3 stage charger with built in Bluetooth. Bluetooth Smart Enabled: Any Bluetooth enabled smartphone, tablet, or other device can be used to monitor, change settings, and update the charger when new software features become available. Instant Readout: The VictronConnect App can display key data, including warnings and

Orion-TR Smart Isolated DC-DC Converter - 24 VDC to 24 VDC - 400W - 17AMP

The Orion-Tr Smart DC-DC charger is a professional DC-to-DC adaptive 3-stage charger with built-in Bluetooth.

Bluetooth Smart Enabled:

• Any Bluetooth-enabled smartphone, tablet, or other device can be used to monitor, change settings, and update the charger when new software features become available.


• Instant Readout: The VictronConnect App can display key data, including warnings and alarms, on the device list page without the need to connect to the product.

Fully Programmable:

• Battery charge algorithm (configurable) or fixed output. Smart alternator compatibility: engine running detection mechanism.


• Adaptive 3-Stage Charge Algorithm: Bulk Absorption Float:


• For lead-acid batteries, it is important that during shallow discharges the absorption time is kept short to prevent overcharging of the battery. After a deep discharge, the absorption time is automatically increased to make sure that the battery is completely recharged.


• For lithium batteries, the absorption time is fixed (the default is 2 hours).


• Alternatively, a fixed output voltage can be chosen.

Suitable for Use in Vehicles with a Smart Alternator (Euro 5 and Euro 6 Engines):

• The built-in engine shutdown detection will stop the converter when the engine is not running. This prevents the unwanted discharge of the starter battery (see manual for details).

Remote On/Off:

• A remote on/off switch or relay contact can be connected to a two-pole connector. Alternatively, the H terminal (right) of the two-pole connector can be switched to battery plus, or the L terminal (left) of the two-pole connector can be switched to battery minus (or the chassis of a vehicle, for example).

All Models Are Short Circuit Proof and Can Be Paralleled to Increase Output Current:

• An unlimited number of units can be connected in parallel.

High Temperature Protected:

• The output current will reduce at high ambient temperatures.

IP43 Protection:

• When installed with the screw terminals oriented downward.

Screw Terminals:

• No special tools are needed for installation.

Input fuse (not replaceable)

Specifications:

• Input Voltage Range: 20-35 V


• Under Voltage Shut Down: 14 V


• Under Voltage Restart: 15 V


• Nominal Output Voltage: 24.2 V


• Output Voltage Adjust Range: 20-30 V


• Output Voltage Tolerance: +/- 0,2 V


• Output Noise: 2 mV rms


• Cont. Output Current at Nominal Output Voltage and 40 Degrees C: 17 A


• Maximum Output Current (10 S) at Nominal Output Voltage: 25 A


• Short Circuit Output Current: 40A


• Cont. Output Power at 25 Degrees C: 480 W


• Cont. Output Power at 40 Degrees C: 400 W


• Efficiency: 89%


• No Load Input Current (2): < 80 mA


• Standby Current: Less than 1 mA


• Galvanic Isolation: 200 VDC between input, output, and case


• Operating Temperature Range: -20 to +55 Degrees C (derate 3 % per C above 40 C)


• Humidity: Max. 95 % non-condensing


• DC Connection: Screw terminals


• Maximum Cable Cross-Section: 16 mm AWG6


• Weight: 1,6 kg (3.5 lb)


• Dimensions (h x w x d) 130 x 186 x 70 mm (5.1 x 7.3 x 2.8 inch)


• Protection Category: IP43 (electronic components), IP22 (connection area)


• Safety Standards: EN 60950


• Immunity Standards: EN 61000-6-2, EN 61000-6-1, EN 55014-2


• Automotive Directive Standards: ECE R10-5