Pay in installments of $25.00 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Aug 18 - Aug 23
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
HobbyWing XROTOR 65A 3-6S AM32 4IN1 ESC FOR FPV RACING - 30x30mmIf you never want to worry about your your 4 in 1 again, Hobbywing's XRotor 65A raises the bar once again! From Captain Vanover himself, this thing is "bullet proof". No matter what type of flight style you choose, this should be a go to 4 in 1 for everyone! The soft mounts prevent most of the vibration from being transferred to the FC. From freestyle to racing, even long range will not challenge this ESC. The 65A Micro 4 in 1 ESC comes loaded with
If you never want to worry about your your 4-in-1 again, Hobbywing's XRotor 65A raises the bar once again! From Captain Vanover himself, this thing is "bullet proof". No matter what type of flight style you choose, this should be a go-to 4-in-1 for everyone! The soft mounts prevent most of the vibration from being transferred to the FC. From freestyle to racing, even long range will not challenge this ESC. The 65A Micro 4-in-1 ESC comes loaded with the latest 32bit tech (the third generation BLHeli_32 code can support up to 128KHz PWM output frequency), DShot1200, Larger FETs, direct pins for a capacitor, and a choice of either a plug n play ESC connector or solder pads for the flight controller.
XT60 pigtail and Cap are soldered on from manufacturer
Check out all our 30x30 Electronics Speed Controllers and the rest of our HobbyWing Products!
Pairs perfectly with the new Hobbywing F7 Flight Controller!
By adopting the open-source AM32 firmware, the XRotor FPV G2 45A & 65A 4-in-1 ESCs benefit from faster update cycles and continuous feature expansion, compared to the closed-source BLHeli-32 firmware. Besides, enhanced compatibility and stability gain ensure exceptional and consistent performance for FPV drone racing.
Higher Power, No Load Worries
The AM32 firmware enables ESCs of the same specifications to sustain higher power output, handling high-load scenarios with ease and providing stronger power support.
Precision Tuning, Quicker Throttle Response
The motor KV value can be entered on the tuning page to finely adjust the motor's response speed and low-RPM acceleration, ensuring more precise control.
XRotor FPV G2 45A & 65A electronic speed controllers adopt next-generation 32-bit ARM F4 MCU running at 120 MHz for ultra-fast computation. In further, these ESCs support variable PWM Refresh Rate from 48 kHz to 96 kHz with dynamic auto-adjustment, delivering smoother throttle control.
Highly integrate four high-performance ESCs in one, XRotor FPV G2 45A & 65A ESCs feature built-in voltmeter which allows flight controllers to monitor the amp and voltage in real time. The shock-absorbing design of mounting holes effectively reduces the external vibration’s impact on high-sensitivity components and provides great shock-absorbing protection to upper devices (i.e. FC).
Features:
- High-performance next-generation 32-bit ARM F4 MCU running at 120 MHz for ultra-fast computation.
-
open-source AM32 firmware
- All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
- The code supports features to prevent sync loss. There are tunable parameters that can make the code run well even in the most demanding situations, although default settings will work excellently in normal operating environments.
- The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us), and Multishot (5-25us).
- Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power-up.
- The code also supports a beacon functionality, where the ESC will start beeping after a given time of zero throttles. This can be very useful for finding lost crafts.
Specifications:
- LiPo Power input: 3S-6S
- Cont.Current: 65Ax4
- Burst Current: 80Ax4
- BEC Output: 5V@ 0.6A
- Input wires: 12AWG-130mm* (Red/Black)
- Output Wire: No wires but solder tabs
- Connectors: (In/Out) XT60 (w/ Wires Soldered on) /no
- Weight / Size: 15.0g / 52x42x6.6mm
- Mounting holes: 30.5x30.5mm
- Throttle Calibration: Supported
- ESC Programming: BLHeliSuite32
Package Includes:
- 1x HobbyWing XROTOR 65A 3-6S AM32 4IN1 ESC FOR FPV RACING - 30.5x30.5mm
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy