SKU: 59260206799

Detrum GAVIN-6C 6CH 2.4Ghz Transmitter w/ SR6-RC iStone 6-Axis Stabilization & Runway Correction Receiver

$108.90 $121.00
Save 10%
No.2 Bestseller on ateurope.org >

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 14 - Jul 19

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Detrum GAVIN-6C 6CH 2.4Ghz Transmitter w/ SR6-RC iStone 6-Axis Stabilization & Runway Correction ReceiverDescription Detrum GAVIN 6C 6CH 2. 4Ghz RC Transmitter The Detrum GAVIN 6C is a 2. 4GHz 6 channel remote controller for RC airplanes, helicopters and multirotors, and is a low power device with a long battery life. It supports four joystick modes, a trainer mode and a failsafe function for increased safety, and can be continuously updated via a USB upgrade program. In addition, the remote controller uses DSSS and FHSS dual spread spectrum technology,

Description

Detrum GAVIN-6C 6CH 2.4Ghz RC Transmitter

The Detrum GAVIN-6C is a 2.4GHz 6-channel remote controller for RC airplanes, helicopters and multirotors, and is a low-power device with a long battery life. It supports four joystick modes, a trainer mode and a failsafe function for increased safety, and can be continuously updated via a USB upgrade program. In addition, the remote controller uses DSSS and FHSS dual spread spectrum technology, which has good signal stability and anti-interference capabilities even in urban areas.

The DSSS&FHSS dual spread spectrum technology will enhance the transmitter by increasing the anti-interference performance and transmission distance. It even can be controlled normally in the city center, do not worry about the strong interference from high voltage lines, signal towers, city WiFi, Etc.

Please click here for Detrum GAVIN-6C 6CH 2.4Ghz RC Transmitter Manual.

The Detrum SR6-RC is a compact, high-performance 6-channel 2.4GHz 3-IN-1 receiver that integrates advanced iStone 6-axis gyro stabilization and Vector runway correction into a single unit.

Designed specifically for RC aircraft, the SR6-RC enhances flight stability, improves takeoff and landing control, and reduces pilot workload—making it ideal for both beginners and experienced pilots.

Compatible with conventional aircraft, flying wings (delta), and V-tail configurations, this receiver delivers reliable performance across a wide range of RC airplane platforms.

Key Features

All-in-One Flight Control Solution

  • Combines Receiver + iStone Gyro Stabilizer + Runway Correction
  • Reduces onboard electronics and simplifies installation
  • Improves reliability and saves space

Advanced 6-Axis iStone Stabilization

  • Built-in MEMS 6-axis gyro with 32-bit ARM processor
  • Real-time correction on roll, pitch, and yaw axes
  • Enhances flight stability and wind resistance

Vector Runway Correction System - Tricycle Gear Optimized

  • Automatically corrects directional deviation during taxi and takeoff
  • Improves ground handling and reduces risk of veering
  • Dedicated WHEEL output channel for nose wheel steering servo

Four Intelligent Flight Modes

Easily switch between modes via a 3-position switch:

  • Gyro Off Mode – Direct control for setup and testing
  • Normal Stabilization Mode – Smooth, stable flight with gyro assistance
  • Attitude Lock (Aerobatic Mode) – Holds aircraft attitude when sticks are released
  • Safe Mode (Self-Leveling) – Automatically levels aircraft for recovery and beginner support

Plug & Play with Smart Calibration

  • Automatic gyro zeroing and stick center calibration
  • No complex setup required
  • Fast initialization on power-up

Wide Airplane Compatibility

  • Standard fixed-wing aircraft
  • Flying wing (delta)
  • V-tail aircraft

Quick Installation & Setup

1. Create a new model on your transmitter
2. Assign a 3-position switch for flight modes
3. Install the SR6-RC near the center of gravity
4. Power on the aircraft on a level surface for auto calibration
5. Adjust servo directions and endpoints in Gyro Off mode
6. Verify gyro correction directions in Normal mode
7. Fine-tune gain and parameters, then proceed to flight testing

Channel Assignment

Channel Function Description
AILE Aileron Roll control
ELEV Elevator Pitch control
THRO Throttle Motor control
RUDD Rudder Yaw control
GEAR Landing Gear Also used for runway correction control
AUX1 Auxiliary Custom function
WHEEL  Steering Output Nose wheel correction servo

 

Runway Correction Logic

  • Controlled via Channel 5 (GEAR)
  • Signal < 1600 μs → Correction ON
  • Signal ≥ 1600 μs → Correction OFF

With landing gear:

  • Gear down → Correction ON
  • Gear up → Correction OFF

Without landing gear:

  • Switch ON → Correction ON
  • Switch OFF → Correction OFF

Installation Guidelines

  • Mount near the center of gravity (CG)
  • Ensure arrow faces forward
  • Align receiver axes with aircraft roll and pitch axes
  • Use included double-sided tape only
  • Keep away from motor, ESC, battery, and moving parts
  • Position antennas at 90°angles for best signal reception

LED Status Indicators

LED Status Meaning
Red flashing (fast) No signal / transmitter off
Red flashing (slow) Ready to bind
Solid green Binding successful / Gyro Off mode
Green flashing Calibration in progress
Solid blue Normal stabilization mode
Solid purple Attitude lock mode - Aerobatic
Blue-green Safe (self-leveling) mode
 Solid red Calibration failed

 

Specifications

Parameter Specification
Channels 6 Channels
Gyro 6-Axis MEMS
Sensitivity -97 dBm
Output Signal PWM (71Hz)
Input Voltage 3.6V – 16V
Dimensions 39 × 20 × 13 mm
 Weight 7 g

 

Why Choose the Detrum SR6-RC?

The Detrum SR6-RC is engineered for pilots who want greater control, smoother flight, and safer takeoffs and landings without adding complexity. Its integrated stabilization and runway correction make it especially valuable for:

  • Scale aircraft pilots
  • Beginners learning fixed-wing flight
  • Pilots flying in windy conditions
  • FPV fixed-wing setups requiring stability and recovery

How to Wire the SR6-RC Correctly:

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 59260206799

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.2 ★★★★★
Based on 1425 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
M
Verified Purchase
Michael
Draper, US
★★★★★ 5
Awesome -- they work perfectly
Style: Updated 3.46in Magnet L Red Hooks 2PCS
Got these to store a DeWalt cordless drill and impact driver on the side of a Gladiator garage cabinet -- and they work perfectly for that. The magnet is incredibly strong, easily supporting the bare tools, and seems even to work perfectly well with an 8ah XR battery on the tool -- not that it's necessary since I don't store them like that. I like that the magnet is padded with rubber. Very nice units, I will get more for sure to store other items.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 26, 2026
B
Bluesman
Phoenix, US
★★★★★ 5
Incredibly strong magnets and thick, robust hooks. Excellent combination!
Style: Updated 3.46in Magnet L Red Hooks 2PCS
These magnetic hooks are really strong. Seriously! Each part is made to carry weight and last. The hooks are built out of thick steel stock. They bolt up to large magnets that grab onto steel surfaces and won't let go. The cabinets in my shop are all steel so these worked perfectly on the sides of the lower units. I have a few #12 AWG extension cords that are bulky and heavy. Truthfully, I didn't think these hooks would handle them. They do without any issue. Another application is a 30' long #10/4 AWG SO cable that powers my powder coating oven. It's usually unplugged and wrapped up. It would often end up on the floor where it was constantly in the way. The outside of the oven is all steel but I didn't want to make holes in it for cable hangers. Again, I didn't think that these magnetic hooks could possibly be strong enough to handle the weight of that cable but they do. And once they're attached, it takes a lot of effort to remove them! Amazing performance!! I'm thrilled with these magnetic hooks. They are super strong and, obviously, simple to use. Importantly, they stay in place as they should. I wholeheartedly recommend these hooks to anyone. Great product! Incredibly strong magnets and thick, robust hooks. Excellent combination!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 12, 2026
A
Andrea
Charlottesville, US
★★★★★ 5
Great for the storm shelter!
Style: Updated 3.46in Magnet L Red Hooks 2PCS, Style: Updated 3.46in Magnet L Red Hooks 2PCS
In our storm shelter we had some lights that we tried to hang up, multiple times, with no luck! Then I found these garage hooks. They are overkill for the lights, but I’m so happy that we now have lighting in the storm shelter. I could think of so many other uses for these. They strength of the magnets is awesome!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 19, 2026
K
KindaPicky
Louisville, US
★★★★★ 4
Magnet is super strong but hooks are not adjustable
Style: Updated 3.46in Magnet L Red Hooks 2PCS, Style: Updated 3.46in Magnet L Red Hooks 2PCS
I ordered this set of Mutuactor magnetic hooks because I was tired of thinking I had things organized and then finding previously hung magnets have slid down the wall. It was a first for me to have to assemble a magnetic hook. This was made slightly more difficult by requiring a wrench. So many items these days arrive with a disposable little hex wrench or whatever is needed for assembly. Not in this case. Maybe the manufacturer assumes if you are spending $15 per magnet to hang your tools you have a wrench handy. Anyway, I got my wrench and found no instructions. I know from life that the order is bolt-washer-lock washer-nut. The next question arose when I found one bolt and several holes... hmmmm. It looks like they wanted to provide the option to screw the hooks directly to the wall. I am not sure the average person would pay that price just for a hook, though. I chose a hole and it seems to be the right one. The good news is I was quickly in business. Soon one magnet was snatched by my husband for his rolling tool cart. He hung his (very heavy) Sawzall and the magnet never moved. He liked the rubber coating that protects his tools. I chose to take advantage of the amazing grip of this thing to hang my most used (and also very heavy) all-clad pan from the side of my fridge. The refrigerator had some sort of glossy powder coat and magnets hold well if you try to pull them straight off but end up sliding down anyway. This is where I came to appreciate the rubber shoe of this magnet. It protects my fridge but I think it plays an essential part in the grip strength of the magnet. I can not slide it around - I need to use two hands to pull it off then place it in another position. To give a magnet strength example I had one magnetic hook on my desk as I was writing this review. My nearby desk-size scotch tape dispenser came sliding over and the magnet grabbed it. I was able to lift the tape dispense just by the magnet grabbing the little piece of metal serrated teeth that cut the tape. There is no other metal in my dispenser. That's it! In summary, four stars because it REALLY grips and holds a lot of weight. Minus a star because I do think they are a little expensive, they required assembly without tools or instructions, and the hooks themselves are not adjustable. I have some similar magnetic hooks and you can move the two prongs apart or together depending on what your tool size is. These prongs are strong and firm and are not moving and this cuts down of the number of uses a little bit.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 12, 2026
F
Francisco P.
Chelsea, US
★★★★★ 5
Develop some quality, worth-while hangups!
Style: Updated 3.46in Magnet L Red Hooks 2PCS, Style: Updated 3.46in Magnet L Red Hooks 2PCS
Organization is key for any shop space. This goes double for smaller shops. If you look around and DON'T see something that could benefit from getting off the floor and onto a peg or hook, I applaud you! For the rest of us, where can we get started? Here you go. These hooks come two in a package. The quality of these are easy to see. The powder coating is very nice as powder coating is more durable than paint. The orange plastic coating on the hooks feels thick and durable. Assembly is easy. There's a threaded post sticking out of the black rubber coated magnet "puck" that you insert into a opening on the hook and secure with washers and a nut. I like that they included both a washer and locking washer. If it matters, I always stack the fastener in the following order: washer, locking washer, then nut. Using a 14mm socket, I was done in no time. How's much will these hooks hold? The magnetic power on these hooks feels substantial. When I slowly approached the side of my metal toolbox, the magnet made an audible snap when it magnetized to the side. It felt strong! The bend at the base of the hook added stability pressing against the toolbox but didn't mark the surface since it was covered by plastic. It held my heavy 50a extension cable and the other hook held both my 25' and 50' pressure washer hoses. Neither moved at all and felt very secure. Whether your shop is your garage or basement, making the most of your space makes a difference and these can help. These are very strong and hold items safely. I'm very happy having these around and will be getting more. If you have a metal surface that you can attach hooks, give these a try. It's a quality solution!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 21, 2026

recommand products

Ghostkeel Battlesuit #460 Tau T'au Empire Warhammer 40k
30.00
Ethereal #443 Tau T'au Empire Warhammer 40k
10.00
3x Krootox Rampagers #463 Tau T'au Empire Warhammer 40k
22.00
* Rukkatrukk Squigbuggy #421 Orks Warhammer 40k
24.00
Sagitaur #442 Leagues of Votann Warhammer 40k
25.00