Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 15 - Jul 20
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Supermicro Motherboard MBD-X13SAE-F-O W680 LGA1700 No Memory ATX RetailForm Factor ATX Processor CPU 12th Generation Intel CoreTM i3 i5 i7 i9 Processors Single Socket LGA 1700 (Socket H5) supported, CPU TDP supports Up to 125W TDP Core Up to 16(8+8) cores System Memory Memory Capacity 4 DIMM slots 128GB ECC non ECC UDIMM, DDR5 4400MHz Memory Type 128GB DIMM Sizes 8GB, 16GB, 32GB Memory Voltage 1. 1V On Board Devices Chipset Intel W680 SATA Intel W680 controller for 8 SATA3 (6 Gbps) ports, RAID 0,1,5,10 IPMI ASPEED
Form FactorATX
Processor
CPU
12th Generation Intel CoreTM i3/i5/i7/i9 Processors
Single Socket LGA-1700 (Socket H5) supported, CPU TDP supports Up to 125W TDP
Core
Up to 16(8+8) cores
System Memory
Memory Capacity
4 DIMM slots
128GB ECC/non-ECC UDIMM, DDR5-4400MHz
Memory Type
128GB
DIMM Sizes
8GB, 16GB, 32GB
Memory Voltage
1.1V
On-Board Devices
Chipset
Intel W680
SATA
Intel W680 controller for 8 SATA3 (6 Gbps) ports, RAID 0,1,5,10
IPMI
ASPEED AST2600 BMC
Audio
ALC 888S HD Audio
Network Controllers
Single LAN with Intel PHY I219LM LAN controller, for AMT/vPro
Single LAN with Intel Ethernet i225LM
Single LAN with Realtek RTL8211F PHY (dedicated IPMI), Dedicated LAN for IPMI
Input / Output
LAN
1 RJ45 Dedicated IPMI LAN port
1 RJ45 Gigabit Ethernet LAN ports
1 RJ45 2.5 Gigabit Ethernet LAN port
USB
4 USB 2 port(s) (2 via header, 2 rear)
4 USB 3.2 Gen2 port(s) (4 rear type A)
3 USB 3.2 Gen1 port(s) (2 via header, 1 Vertical)
2 USB 3.2 Gen2x2 port(s) (1 rear type C, 1 via header)
Video Output
1 VGA port(s), 1 DVI - D port(s), 1 DP 1.4a port(s), 1 HDMI 2.1 port(s)
Serial Port
1 COM Port(s) (1 header)
TPM
1 TPM Header
Expansion Slots
PCI-E
2 PCI-E 3.0 x4,
2 PCI-E 5.0 x16 slots (16/NA or 8/8)
1 - 5V PCI 32bit
M.2
M.2 Interface: 3 PCI-E 4.0 x4, RAID 0, 1, 5
Form Factor: 2280
Key: M-Key
System BIOS
BIOS Type
256MB SPI Flash with AMI BIOS
BIOS Features
ACPI 6.0
Plug and Play (PnP)
BIOS rescue hot keys
Riser card auto-detection support
SMBIOS 3.0 or later
Management
Software
SuperDoctor 5, SUM, SSM, AMT, vPro, Watchdog, IPMI (Intelligent Platform Management Interface) v2.0 with KVM support
System Management Software
SuperDoctor 5
Power Configurations
Power-on mode for AC power recovery, ACPI Power Management, Power button override mechanism, Wake-on-LAN
PC Health Monitoring
Voltage
VBAT, System temperature, CPU temperature, 3.3V standby, 1.05 (PCH), +5V standby, +5V, +3.3V, +12V, CPU thermal trip support, +1.8V PCH
LED
Power LED
Catastrophic Error LED
FAN
5x 4-pin fan headers (up to 5 fans)
Fan speed control
Overheat LED indication
Other Features
CPU thermal trip support for processor protection, Control of power-on for recovery from AC power loss, Chassis intrusion detection, ATX Power connector, ACPI power management, 8-pin 12v DC power connector
Operating Environment
Operating Temperature Range
0oC - 50oC (32oF - 122oF)
Non-Operating Temperature Range
-20oC - 60oC (-4oF - 140oF)
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.3 ★★★★★
Based on 1705 reviews
Sort
Product Reviews
★★★★★ 5
Works perfectly with Macbook Air M2 - power, audio, video, sleep/wake, in clamshell mode!
My monitor has a USB-C video input that supports power delivery - so I was supposed to be able to charge my laptop with the same connection that goes to the monitor. Have had trouble finding an unpowered hub that actually supports all this without any hiccups, but according to all the specs I knew this was supposed to be possible.
But this one does! Now I can connect my apple laptop to my monitor, keyboard and mouse, and run in clamshell mode or with the laptop open, and it charges, wakes from sleep, does all the things I want. It also sends audio to the monitor (as it should). And I only need one USB-C connection to my laptop to do all this.
Note: I just got this hub so I don't know about longevity, and I haven't tested transfer speeds from all the ports on the hub, because that's not a big concern for me.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 25, 2026
★★★★★ 5
So far, so good. It's a USB-C hub, Anker has been doing USB hubs and power supplies for many years
I've always been impressed with Anker products, and great customer service! I do feel like they are starting to abandon the Android side of things recently, and the selection of cables has declined. USB-A cables seem to be discontinued, as well as USB-B.
I did have a really great CSR experience a while back. I had bought a Lithium Ion car battery jumpstarters, and had not used it for several years. I needed it one night, and the cables to connect to the battery had failed. Couldn't start my car. Even though the warranty was expired, and the product was even discontinued, they shipped me (at their cost) a replacement set of cables. Now a loyal customer.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 2, 2025
★★★★★ 1
Poor quality junk
Poor quality. Does not work as advertised. Do not buy this junk.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 14, 2026
★★★★★ 3
good on 16-inch MacBookPro and ThinkPad but not 13-inch MacBookPro; intermittent USB 3.2 connections
UPDATE 2025-NOV - lowering to 3-stars:
Found that only the 2nd USB-C from the right is truly USB 3.2 compliant. Using the same SSD and same USB-C 3.2 cable, only the 2nd port from the right connects at 10Gbps speeds for RTL9210B-chipset enclosure SSDs (and I have tested with 4 different ones). The other 2 ports on this Anker adapter are intermittent, sometimes they connect the SSD as USB 3.0 and sometimes it connects as USB 2.0, for the same SSDs. The odd thing (as possible workaround) is that if we use a USB-C to USB-A female adapter and then use a USB-A to USB-C cable to the same SSD, it now connects at USB 3.0 speed on any of the ports, but transfers only at 5Gbps throughput.
Another annoying thing is, this Anker adapter, even after the firmware upgrade, still intermittently "sleeps" or "goes offline" and disconnects from the laptop (does this on both my MacBook and ThinkPad). It does automatically reconnect after a few seconds, but very annoying, and can possibly corrupt drives that are connected when it happens.
ORIGINAL REVIEW - 4 stars:
USB-C hub is fast, able to transfer 5+ Gbps to SSD.
Video display quality is OK for 1440p (when it works).
DisplayPort video worked on ThinkPad and 16-inch MacBookPro, but not on 13-inch MacBookPro; connecting to a USB-C connected monitor (video worked without this Anker adapter).
USB-C cable length to host computer is long enough.
Worth the $30 price I paid ... yes; it served the purpose of having a USB-C hub while still being able to use the USB-C port for DisplayPort video; overall good design.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on September 10, 2025
★★★★★ 4
Video output does not contain power — caveats and findings for Switch users to whom this may concern
The product works with some caveats, which I initially tried to resolve with an ultimately unsuccessful firmware upgrade. (Anker was responsive via email, much appreciated.) It turns out the product was working to the best of its abilities this whole time, which I will now expound upon.
I expect that perhaps another 4-5 people in the world intended to use this in the ways that I did, namely with a Nintendo Switch as the source to various output devices. If you are one of these people who are interested in reading my experience connecting this hub with a Nintendo Switch, my findings are below (after a brief primer).
A Brief Primer
1. As you know, the Nintendo Switch can be coaxed to output Dp-Alt video if you can satisify a 39W+ handshake (15V, 2.6A or higher)
2. There are other adapters that will do this and output the video (with ample power) over USB-C, which are useful for powering AR glasses, portable monitors, or desktop USB-C monitors.
3. The limitation of a USB-C Dp-Alt adapter is that it does not also provide USB data ports like the Switch Dock itself, while many USB-C to HDMI dongles include USB-A ports. (But we don't want HDMI out, of course, because using USB-C we can power AR glasses or a portable monitor and send the video signal with one cable.)
4. I surmised that, by chaining a USB-C Dp Alt Adapter to this one (Anker A8340), I could have video output and three USB-C ports. Why do I want USB-C data ports? Since you are like me, you already know it is so I can connect a UAC1 DAC to output USB Audio and power thirsty headphones via a 4.4mm Pentacon balanced headphone jack. I also don't need to convince you of the merits of this versus using the Switch's built in 3.5mm headphone jack. Or say, connecting a wired controller because I don't care for input latency if I can avoid it.
My Findings
1. This hub can indeed be chained to a USB-C Dp-Alt adapter and pass through a video signal while also leaving three USB 3.2 data ports for wired devices (yes!)
2. However, as other reviews kindly mention, the video signal outputted by the A8340 does not contain power of any sort. So, if you are intending to plug this into a desktop USB-C monitor which already has/doesn't need power, then everything is awesome.
3. If you are trying to power AR glasses, this won't work unless you add a second USB-C DP-Alt adapter after it, and provide power that way. If you intend to convert the video signal to HDMI or DisplayPort via a USB-C to HDMI or DP cable, these won't work because there is no power for the inline conversion.
4. If you are using a USB-C travel monitor, this will work provided you directly power the monitor via its second USB-C power (if it has one).
So in summation, it's possible to get what you want, though you may find the victory pyrrhic. The perfect adapter (which I had hope this was, and may yet exist at a higher price point) basically takes a USB-C Dp-Alt adapter, adds USB-C data ports, and outputs USB-C + power to power AR glasses or a travel monitor.
This device nevertheless has its uses, such as the ability to connect multiple USB-C devices to the Switch in handheld mode and charge it, too.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 30, 2025