K-Tuned Billet Throttle Body - K-series 80mm (RBC manifold)

• O-Rings Sealed

• K-Tuned throttle cables should be used with K-Tuned TB's. In most cases the stock cables will NOT be the correct length
• No MAP Sensor or IACV Sensors ports, these are now deleted

K-Tuned 80mm Throttle Body Uses that popular bolt pattern from the 86-93 Ford Mustang 5.0L. This allows the throttle body to bolt up perfectly to some of the bigger aftermarket race style intake manifold options. The 80mm K-Series TPS and comes standard with a 3.5" barb inlet. As with Ktuneds previous designs, the throttle spring tension can be adjusted to suit the driver. 

The base of the throttle body and the inlet are o-ring sealed so there is no need for additional gaskets. The throttle cable connection is easy, using the adjustable row rotor with a lower profile, stainless throttle cable bracket. All K-Tuned Throttle Bodies are constructed with 6061-T6 billet aluminum with a brass throttle blade and a stainless steel throttle shaft. Shaft seals are leak tested to 90psi.

Application:

• RBC Intake Manifold to K-Tuned 80mm Throttle Body

Note:

• The adapter are O-Ring sealed so there is no need for a gasket between adapter or manifold
• Confirm that the 80mm TB you are using has a gasket

The 2 piece design adapter plates allows an 80mm TB to be used on a RBC intake manifold. K-tuned is offering them separately for those wanting to run our Domestic Style Throttle Body or other aftermarket options.

By using a specialized set of billet adapters Ktuned has made it possible to port out the TB opening including IACV section on the RBC manifold. This porting increase the size of the TB opening and allows the 80mm TB to breathe perfectly through the newly ported off-round hole.