One Mfg Lips Stomp Pad 5"x5"

One Mfg Lips Stomp Pad 5"x5"Snowboard Stomp Pad Traction Pad. Glossy Lips snowboard stomp pad. Clear material with ONE MFGs new and improved cone shaped stud design to give your boot more traction on the board when getting off chair lifts or riding with one foot strapped in. Keep your foot where it should be! Make your board look like it is cooking delicious sizzling bacon! This stomp pad is molded and then produced in their Belfair Factory! Size: 5" x 5" Instructions: Clean

Snowboard Stomp Pad/Traction Pad. Glossy Lips snowboard stomp pad.

Clear material with ONE MFG’s new and improved cone shaped stud design to give your boot more traction on the board when getting off chair lifts or riding with one foot strapped in. 

Keep your foot where it should be! Make your board look like it is cooking delicious sizzling bacon!

This stomp pad is molded and then produced in their Belfair Factory!

Size: 5" x 5"

Instructions: 

1. Clean board surface and dry completely. Use ONE MFG Base Cleaner, rubbing alcohol, or another solvent may be needed to get off dirt. Let the solvent dry for 10 minutes. 

2. Mark the area where the pad will be placed with pencil first. Peel off the backing of the pad. Place the stomp pad in front of your back foot binding and center edge to edge.

3. Only stick once, do not move, making sure not to damage adhesive. Use your fingers to press on the pad with firm pressure. Use a hair dryer or heat source to help the pad stick if you want. 

4. Let the stomp pad adhere to the board for a minimum of 12 hours before using. Better yet, bring your board inside your house and let the stomp pads rest overnight.