SKU: 71445948679

3CD - Warrior - The Complete Sessions

$40.49 $44.99
Save 10%
No.2 Bestseller on ateurope.org >

Pay in installments of $11.25 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Aug 11 - Aug 16

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

3CD - Warrior - The Complete Sessions3CD UK Import The most complete and best sounding 3CD collection of Warrior's short career. A treasure trove demonstrating the power, quality and sheer momentum of Warrior, and adding to the band's legacy and legend. The Warrior story goes back to 1982 when New England band members Jimmy Waldo on keyboards, bassist Gary Shea and drummer Hirsch Gardner were searching for a replacement for recently departed guitarist, John Fannon. A then unknown

3CD - UK Import

The most complete and best sounding 3CD collection of Warrior's short career. A treasure trove demonstrating the power, quality and sheer momentum of Warrior, and adding to the band's legacy and legend.

The Warrior story goes back to 1982 when New England band members Jimmy Waldo on keyboards, bassist Gary Shea and drummer Hirsch Gardner were searching for a replacement for recently departed guitarist, John Fannon.

A then unknown guitarist Vincent Cusano was recommended by KISS's Gene Simmons, as both bands were represented at the time by manager Bill Aucoin. Cusano was a prolific songwriter, and sent some of his song ideas to the Boston based New Englanders for consideration.

So impressed was the trio with Cusano's songwriting abilities that they agreed to relocate to Los Angeles where the guitarist was based, and the band Warrior was born. Recording began at the famed Record Plant with serious interest from CBS Records, but the band were also diligent enough to record demos and rough ideas on a more modest set-up, capturing the fledgling band on cassette.

Unfortunately for Warrior, Vincent Cusano's talents meant that the guitarist was snapped up by KISS in 1982 to replace Ace Frehley for their 'Creatures Of The Night' LP, which was their last in make-up, and now rechristened Vinnie Vincent. Those rare recordings gathered dust until HNE released a collection of them in 2017.

Subsequently, more tapes and cassettes, some of significantly better quality, have been unearthed from Gary Shea's personal archive. Also included are a number of the demos and rehearsals. Shea and Waldo would remain in Los Angeles, soon joining up with Rainbow vocalist Graham Bonnet to form Alcatrazz with Yngwie J. Malmsteen.

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 71445948679

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.2 ★★★★★
Based on 14 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
D
Verified Purchase
David Spencer
Chelsea, US
★★★★★ 5
Good stuff
Material Type: 157mil Closed Cell Foam, Style: 157 mil 36 SqFt
Good stuff, easy to use, self adhesive backing contours around curves easily and works great.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 29, 2026
S
Verified Purchase
stookie778
Pawtucket, US
★★★★★ 5
Works amazingly, but only if you install it correctly.
Material Type: 157mil Closed Cell Foam, Style: 157 mil 36 SqFt
If you purchasing Siless Liner 157 mil (4 mm) Sound Deadening mat, to block unwanted sounds in your car, this is what you need to buy. But wait! It's not the only thing you need to buy if you want to "actually" deaden sound. By itself, it will definitely block a noticeable amount of sound, and, most likely, that's all you realistically need. But... But... If you want the Siless Liner Sound Deadening Mat to really help you take it up a few notches, to get the best sound almost bordering on soundproofing, listen up. You will have to install traditional butyl rubber first. Doesn't have to be the Siless brand, but I'm sure they would love to sell both to you, I used both Killmat (80mil) and Noico (50mil). I have a Honda S2000. It's a two-seater convertible sports car if you don't know what this car is, and it's loud when I'm driving above 60mph. I also happen to have a sound system installed as well. Other than that, the car is stock. I first installed the butyl rubber on the car's interior sheet metal. I went all out and covered everything I could. I didn't need to but I wanted to. I was extremely impressed with the results. But I wanted to go further. Not because I needed to but because just wanted to see what it would be like. So I bought Siless Liner 157 mil (4 mm) 36sqft Sound Deadening mat to go on top of the butyl rubber mats. I put this over every area I installed the butyl rubber. I had to be careful of clearance issues since I added a significant amount of underlayment, and you should too. If you put butyl rubber sound-deadening materials in 50% of the total interior area, you'll hear a noticeable improvement. If you put butyl in about 80% of the total area, you'll be even more amazed at the improvement, compared to before. I originally did all the above myself, so that's my experience and so your mileage may vary. I then installed the Siless Liner Sound Deadening mat over every place I could even going further than I could with the butyl rubber. I used the Siles Liner in areas where butyl rubber would not have been effective, such as the roll bar hoop area and large empty cavities or holes. I covered everything I could, firewall, doors, floor pan, transmission tunnel, trunk, trunk lid, fuel tank area, rear quarter panels, and rear-wheel tunnels, in Siless Liner Sound Deadening Mat. WOW!! The Siless Liner Sound Deadening Mat was the icing on the cake! Let's not forget, this car is a convertible sports car so it will never be a quiet ride, ever. But I can now actually have a conversation with a passenger at a normal-ish volume! This also means I can now have a normal hands-free phone call without having to plug one ear to block out the noise! My sound system sounds so much better! Just by going through the install process, I looked for any vibration, rattle, squeak, and noise-prone areas to either eliminate or reduce unwanted noise production. If you forget this step, the inside and outside of your car will rattle and buzz. I skipped this step the first time around. But did it right before I installed more butyl rubber and the improvement was impressive, especially inside the car. Outside the car, I didn't notice a difference until I put the last layer of Siless Liner Sound Deadening Mat. The sound deadening mat works both ways from what I can tell. If I turned up my music, as loud as I occasionally do, parked in the attached garage to the house, with the garage door closed, I would be barely able to tell the car was playing music in the garage. It sounds like it is another car, just a little bit down the street, with a very loud base. If you stand 20 feet away outside the car, the sound system is noticeable, but not obnoxious by a long shot. Get a 3 piece wood/metal roller set as well, which makes quick work of large areas.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 23, 2021
L
Verified Purchase
Ligia
Waukegan, US
★★★★★ 5
Better than Kilmat
Material Type: 157mil Closed Cell Foam, Style: 157 mil 36 SqFt
Great adhesion, and you can immediately see the sound difference when you rap the area and compared it to another area without it. Also, very easy to cut and apply. Once on, you may not be able to peel it and reposition it, so be sure where you want it.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 2, 2026
J
Verified Purchase
J M.
San Leandro, US
★★★★★ 3
Not much noise reduction…
Material Type: 157mil Closed Cell Foam, Style: 157 mil 36 SqFt
Easy to install but did not provide much sound dampening…
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 28, 2026
M
Verified Purchase
Mike
Battle Creek, US
★★★★★ 5
Great sound mat for the price!
Style: 50 mil 50 SqFt, Style: 50 mil 50 SqFt
This is a good product. Many people go with KILMAT because of the value to price point. I did as well. When you clean the surface (in my case it was all painted metal) this stuff sticks very well. I do recommend you use a seam roller of some type, I used Lumiteco 3 piece roller set. This will help with adhesion and mostly flatten the overlapped edges. It also helps you see where you have rolled as it leaves little grooves. The difference when we had no sound mats and after was very impressive. We haven't finished our install yet and it is quieter than when we had an interior in the van. There are thicker mats available in other brands, but this will work great for our van build, but this helps keep the weight down. It is quality material, just be careful when you are removing the backing, the edge of the foil face can cut you. I suggest you layout where you are installing the mat and cut to fit. From what I have read, you don't need to cover every inch in the vehicle, just spot install for a big difference. I chose to cover most surfaces to help keep sound out when we are sleeping in the van. We haven't finished putting the van yet, but we have driven it around and been very satisfied with this product.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 3, 2025

recommand products

Peugeot Boxer / Manager (2006-ON) Exhaust Mount - Cat Section EXH015
13.56
Porsche 911 964 (1989 - 1994) Front Wishbone Front Bush PFF57-102
102.24
Peugeot RCZ (2009-on) Front Anti Roll Bar Bush 24mm PFF50-603-24BLK
55.32
Peugeot RCZ (2009-on) Front Anti Roll Bar Bush 22.5mm PFF50-603-22.5
49.20
Peugeot 306 (1993-2002) Rear Beam Mount Tensioning Kit PFR50-300
21.30