SKU: 26607700899

Kidde Firex 3x KF20LL Optical Smoke & 1x KF30LL Heat Alarm Kit Mains Powered with Long-Life 9V Lithium Battery Back-Up

Sale price$89.10 Regular price$99.00
Save 10%

Pay in installments of $24.75 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Aug 18 - Aug 23

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Kidde Firex 3x KF20LL Optical Smoke & 1x KF30LL Heat Alarm Kit Mains Powered with Long-Life 9V Lithium Battery Back-UpKidde Firex 3x KF20LL Optical Smoke & 1x KF30LL Heat Alarm Kit Mains Powered with Long Life 9V Lithium Battery Back Up FULLY COMPLY WITH THE NEW 2022 SCOTTISH & WELSH REGULATIONS 3x Mains Powered Optical Smoke Alarm (KF20LL): Mains Optical Smoke Alarm Features: Mains powered optical smoke alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat. Once interlinked, the detection of the relevant danger by

Kidde Firex 3x KF20LL Optical Smoke & 1x KF30LL Heat Alarm Kit Mains Powered with Long-Life 9V Lithium Battery Back-Up

FULLY COMPLY WITH THE NEW 2022 SCOTTISH & WELSH REGULATIONS

3x Mains Powered Optical Smoke Alarm (KF20LL):

Mains Optical Smoke Alarm Features:

Mains-powered optical smoke alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat.
Once interlinked, the detection of the relevant danger by an individual unit will sound across all the connected alarms.
Optical alarms are for use in escape or circulation routes and in areas where there is a danger of ignition of furniture and surroundings by cigarettes producing slow, smouldering fires.
This mains-powered unit should be installed by a qualified electrician and can be used throughout the home, except in the kitchen where a Firex Heat Alarm is recommended. These alarms comply with UK Building Regulations for new housing and associated standards (Grade D BS 5839, Part 6).

  • Interlink with up to 23 Firex hard-wired alarms – all alarms sound if danger is detected
  • Alarm memory – identifies source unit within interconnecting network
  • Combined Test/Hush button allows regular testing of alarm function and can be used to temporarily silence nuisance alarms
  • Auto reset after activation
  • Tamper-resistant locking device – prevents unauthorised removal without the use of a tool
  • Mains operation – 9V Lithium back-up battery supplied as standard

Mains Optical Smoke Alarm Specification:

  • Model KF20LL
  • Power Supply 230V mains-powered with 9V Lithium battery back-up
  • Temperature Range 0ºC to + 40ºC
  • Humidity Range Up to 93% Relative Humidity (RH) non-condensing
  • Storage and Transport -20ºC to +60ºC and 5–95% relative humidity (RH) non-condensing
  • Alarm Dimensions 127 x 127 x 39mm
  • Bracket Dimensions 133 x 133 x 6mm
  • Alarm Weight 242g
  • Warranty 6 years
  • Approvals BSI certified to BS EN14604:2005
  • CE tested and certified Sensor Optical, circular lateral chamber with insect-resistant width slot entry portals and added bug screen mesh
  • Chamber Size 35mm outside diameter x 16mm depth approximate (external)
  • Detection Band Infrared light wavelength
  • Button Test Simulates the effect of smoke within the sensing chamber, checks electronics and sounder
  • Automatic Self-test Circuitry is tested and unit beeps (chirps) if fault is detected
  • Supply Voltage 230V AC, 50 Hz (nominal UK voltage)
  • Power Consumption < 15mA
  • Connection Push-in/snap-fit type connector with 150mm long flying leads (supplied)
  • Battery Back-up User-replaceable alkaline 9V battery (522/6LR61)
  • Power-on Indicator Continuous green LED
  • Alarm Sounder Electronic piezo-electric sounder (T3 pattern sound - 3 pulses - space - 3 pulses), soldered contacts
  • Sound Output 85dB (A) minimum at 3 metres
  • Alarm Frequency 3.2 kHz typical
  • Dust Protection In-built foam gasket in rear of alarm to prevent dust ingress into rear of the alarm
  • Alarm Status Red LED flashes approx once every five minutes = normal operation
  • Red LED flashes once a second = sensing smoke (sounder alarm sounds)
  • Red LED flashes once every ten seconds = in hush condition (auto-reset after 15 minutes)
  • Interconnection Up to 24 Firex and Kidde ‘Slick’ units (smoke, heat and CO) can be hardwire interconnected with optional control (see below)
  • Optional Controls Wired Remote Test and Hush Unit (REMTH) allows test and hush of interlinked units
  • Optional Pattresses SMK23RU also has integral switchable relay for operating remote devices
  • SMK4896 – Surface mounting base for added ease of installation
  • Fixing Mounting bracket ring supplied with two ‘T’ slot fitting option
  • 57mm spacing to a maximum of 90mm for standard screw fittings on back boxes
  • Bracket has 50mm diameter central access hole for cabling
  • Plastics used NORYL – Cover, main body and mounting bracket
  • Lead-Free Status All Firex alarms are lead-free

1x Mains Powered Heat Alarm (KF30LL):

Mains Heat Alarm Features:

Mains-powered heat alarm that can be interlinked with up to 23 other Kidde mains alarms, be they ionisation, optical or heat.
Once interlinked, the detection of the relevant danger by an individual unit will sound across all the connected alarms.
Mains-powered heat alarms can be used throughout the home in humid or dusty environments where an optical or ionisation smoke alarm is unsuitable, e.g. kitchens, loft spaces and garages.
The Firex range requires installation by a professionally qualified electrician and complies with UK Building Regulations for new housing and associated standards (Grade D BS 5839, Part 6).

  • Interlink with up to 23 Firex hard-wired alarms – all alarms sound if danger is detected
  • Alarm memory – identifies source unit within interconnecting network
  • Combined Test/Hush button allows regular testing of alarm function and can be used to temporarily silence nuisance alarms
  • Auto reset after activation
  • Tamper-resistant locking device – prevents unauthorised removal without the use of a tool
  • Mains operation – 9V Lithium back-up battery supplied as standard

Mains Heat Alarm Specification:

  • Model KF30LL
  • Power Supply 230V mains-powered with 9V Lithium battery back-up
  • Temperature Range 0ºC to + 40ºC
  • Humidity Range Up to 93% Relative Humidity (RH) non-condensing
  • Storage and Transport -20ºC to +60ºC and 5–95% relative humidity (RH) non-condensing
  • Bracket Dimensions 127 x 127 x 39mm
  • Alarm Dimensions 133 x 133 x 6mm
  • Alarm Weight 213g
  • Warranty 6 years
  • Approvals BSI certified to BS5446 Part 2: 2003
  • CE tested and certified
  • Sensor Thermistor (Thermal Resistor) within detection unit
  • Button Test Simulates the effect of heat at the sensor, checks electronics and sounder
  • Automatic Self-test Circuitry is tested and unit beeps (chirps) if fault is detected
  • Supply Voltage 230V AC, 50 Hz (nominal UK voltage)
  • Power Consumption < 15mA
  • Connection Push-in/snap-fit type connector with 150mm long flying leads (supplied)
  • Battery Back-up User replaceable alkaline 9V battery (522/6LR61)
  • Power-on Indicator Continuous green LED
  • Alarm Sounder Electronic piezo-electric sounder (T3 pattern sound - three pulses - space - three pulses) with soldered contacts
  • Sound Output 85dB (A) minimum at 3 metres
  • Alarm Frequency 3.2 kHz typical
  • Alarm Status Red LED flashes approx once every five minutes = normal operation
  • Red LED flashes once a second = sensing heat in excess of 58ºC (sounder alarm sounds)
  • Interconnection Up to 24 Firex and Kidde ‘Slick’ units (smoke, heat and CO) can be hardwire interconnected with optional control (see below)
  • Optional Controls Wired Remote Test and Hush Unit (REMTH) allows test and hush of interlinked units
  • Optional Pattresses SMK23RU also has integral switchable relay for operating remote devices
  • SMK4896 – Surface mounting base for added ease of installation
  • Fixing Mounting bracket ring supplied with two ‘T’ slot fitting option
  • 57mm spacing to a maximum of 90mm for standard screw fittings on back boxes
  • Bracket has 50mm diameter central access hole for cabling
  • Plastics used NORYL – Cover, main body and mounting bracket
  • Lead-Free Status All Firex alarms are lead-free

Please note: Alarms are sold individually.

Data Sheet:

Data Sheet for KF20LL
Data Sheet for KF30LL

Instruction Manual:

Instruction Manual for KF20LL
Instruction Manual for KF30LL
Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 26607700899

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.1 ★★★★★
Based on 20 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
H
Verified Purchase
Hawaiian
Phoenix, US
★★★★★ 4
Great shoes that are well made, lite weight, and comfortable.
Size: 12, Color: Brown
Just received my 2nd pair of shoes from Bruno Marc in a size 12. These are really lite and comfortable. It can be dressed down to be a casual shoe or dressed up with a nice suit. These run true to size so I ordered my usual size 12 and the fit was perfect. Being my 2nd pair of Bruno Marc's, I like the quality of their shoes and each shoe is described appropriately on fit and comfort. Insole of these shoes were awesome and provided soft comfort on the feet along with a slight arch support too. Will definitely consider ordering more Bruno Marc shoes in the future.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 11, 2025
J
Verified Purchase
JCMIV63
Belleville, US
★★★★★ 5
Cushioned, comfortable, stylish and a rubber sole!
Size: 10, Color: Brown
These shoes check multiple boxes for me, comfortable, cushioned, rubber sole and stylish. As my feet grow old and worn out, I'm on a constant search for comfortable, cushioned shoes that are suitable for work and dressier occasions. I have tried many expensive shoes that look great but either lack cushioning, arch support and or comfort. One of the nice things is these shoes have a rubber sole, where most cushioned shoes have the foam soles which are great, but they tend to lack grip particularly when its damp/wet. They have average arch support, but the insole is removable and I put my own cushioned arch support. Love these!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 6, 2026
D
Verified Purchase
DDD Projects
Port Orchard, US
★★★★★ 5
OG Style
I am a big fan of Bruno Marc shoes. Over the years they have provided comfortable and affordable boots and shoes. These blue, tan and white soled dress sneakers are no exception. They have a nice finished look that makes them both causal and dressy. The lightweight style is still warm enough for colder mid-west winters. The box of the toes is wide and comfortable. The insole is well padded and a pleasure to wear. This is another fine pair of shoes to add to my collection and yours.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 14, 2026
P
Verified Purchase
Premium Reviews
Dallas, US
★★★★★ 5
Must buy: Comfort + Casual + Well Made / Ventilated
Size: 8, Color: Brown
Just buy it! I have put in roughly 15,000 steps in this shoes in 10 days and I can't believe how comfortable they are after this much rough use in short amount of time. I highly recommend this shoes to anyone looking for comfort in casual style.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 4, 2026
W
Verified Purchase
William W.
Massapequa, US
★★★★★ 5
WIDE Dress Shoes With SUPPORT
Size: 10.5, Color: Brown
I've seen dress shoes and worn dress shoes before, but these are simply the best dress shoes I've ever worn my entire life. 99% of dress shoes have the same problem, they have the thinnest little soles that offer no support. BRUNO MARC HAS SOLVED THE PROBLEM. These dress shoes not only support wide feet like mine who historically have had and still have little support in the market, but Bruno Marc has wide options that fit perfectly, and the support with the thick foam sole is so needed and awesome. I had a pleasant surprise putting these things on and there being some tactile grip enhancers inside the shoe so you can feel the shoes better and get a little tickle / massage while you're at it. These things are dripping with style, easy to wear, and while they might look firm on the outside, on the inside the shoe just has such a nice flexibility and foamy feel, the top where the top of your feet feel the roof of the shoe, it has such perfect ooey gooey support I can't believe it. The outside sole also has this neat tactile feel. The durability looks good and feels good for now.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on September 28, 2025

recommand products