Syousin Suminagashi R2 Damascus Gyuto 270mm by Shiro Kamo

Syousin Suminagashi R2 Damascus Gyuto 270mm by Shiro KamoSyousin Suminagashi R2 Damascus 270mm Gyuto Weight 231 g Total Length 281 mm Tip to Heel Length 431 mm Blade Height at Heel 58 mm Width of Spine Above Heel 2. 6 mm Width of Spine at Middle of Blade 1. 9 mm Width of Spine at about 1cm From the Tip 1. 2 mm Steel R2 PM Core, DamascusStainless Cladding Hardness HRC 62: 63 Handle Design Rosewood Handle Pakkawood ferrule K&S is proud to announce the availability of the long awaited budget R2 line: the

K&S is proud to announce the availability of the long awaited budget R2 line: the Syousin Suminagashi by Master Shiro Kamo from Echizen, Japan. The knife features western blade profiles (Gyuto, Sujihiki, etc), with traditional Japanese octagonal handles in rosewood. The blade is sanmai construction, with the famous R2 powdered alloy core steel cladded with a beautiful hand forged soft Damascus stainless steel. Forged by master smith, with exceptional performance and artistic, yet the most important part is, it is surprisingly affordable. K&S is determined to provide customers around the world with the best products at the best prices possible.

The Steel

R2 is a type of PM steel (Powder Metallurgy) that is long regarded as the best all-rounder steel for kitchen knives. The PM process produce a very fine grain for the steel, so it gets sharper than the traditional non-PM steel; the added Vanadium and Molybdenum give the steel excellent wear-resistance and toughness, means it is less likely to chip and keeps the edge much longer.

The wear-resistance property of PM steel can sometimes be a double-sword for kitchen knives. That is, if the blade is made of mono-steel construction (non-cladded, usually done by stock removal), the excellent wear-resistance property means the bevel is notoriously hard to thin and refinish (generally speaking all the monosteel knives are more or less like so, but PM steel is that much harder).

Now the beauty of sanmai construction kicks in. Sanmai literally means “three pieces”: a thin layer of core steel is sandwiched between two layers of soft iron or stainless steel. Doing so not only allows the knife to cut as good as a monosteel knife (core steel doing the work), but more importantly, enables the knife to be thinned with ease (removing the soft cladding rather than a hard steel with hardness over HRC 60). In the case of Syousin Suminagashi line, the soft cladding is even hand forged by Kamo-san with an eye catching Damascus pattern.

About Shiro Kamo

Fig: Master Shiro Kamo forging a Syousin Suminagashi blade at the Takefu Knife Village, Echizen, Japan

Shiro Kamo, while little known overseas, is a well regarded knife smith in Japan. He was awarded the prestigious “Dento-kogeshi” (Master of Traditional Crafts) at a very young age (total of about 10 persons are awarded in Echizen area, likes of Takeshi Saji and Katsushige Anryu). He is also the president of the Takefu Knife Village Cooperative (http://www.takefu-knifevillage.com/company/) that is the reason I say while not known by many of us outside, Kamo-san is certainly a highly regarded figure in the kitchen knife industry. His knives have exceptional profile and grind, and the heat treatment of R2 steel is so impressive that you are assured to be getting a damn good knife. I just can’t afford to not offer his work to you :D

Fig: Master Shiro Kamo forging a Syousin Suminagashi blade at the Takefu Knife Village, Echizen, Japan